1. Adopt infrared weld technology
which independent exploration.
2. Use infrared heat,it is easy to cut through,heat
proportion piercing tradition weld machine with
sirocco.
3. Easily operate.Just need one day training.Can
operation this machine.
4. No need weld tools,it can weld all the component
of 15-45cm.
5. This machine has 650W heating system.widely to
120*120mm.
6. Infrared heating no have sirocco flow. Don't
impact perimeter small component.Can suitable for
all of the
component,especially Micro BGA component.
Parameter:
Working voltage : AC220V 50Hz
Output power: 800W
Temperature: 60?-350?
------------- 
--------- 
User
Manual
1 - Boot.
Check the power source,wind the plug.
Turn on the power source.Don’t use until
pass check.Pand will display enactment value.When
last time used.
Installation the repair shell. Fix the line on
the strip rack. Screw the light system height.Keep
20-30mm between light and welder machine.
Accordingtomeasurement of welder piece.Proprictily
screw temperature.from60C-460C.When you strip
15×15mm piece.Choice temperature 240-350C.When
you strip 30×30mm piece.Choice temperature
250-460C.The temperature come up to 460C.The light
system will shoot straightly.Please pay more attention
to yourself control time.avoid burn out.
Screw focus.The light system smallest diameter
is 15mm .the biggest is 30mm.Normally keep 20-30mm.
Turn on the two switches.They control warm-up
plate and light system.
2
Dismantle and weld
Regulate temperature , make the chip focus
After suitable for timing, the tin is clicked
and melted, take out the chip
Weld
the chip
Clean the pad
Coating help solder flux (should not thick too
, can have first more thin ) and soldering tin
ball?
Wait to help the solder flux to volatilize into
the flux, heat and totally melt to the tin ball
, place correctly with the clip , aim at the chip
to weld into the position.
|
